Mounting The Indoor Unit; About Mounting The Indoor Unit; Precautions When Mounting The Indoor Unit; To Install The Indoor Unit - Daikin Altherma 3 R F Installer's Reference Manual

7.4 Mounting the indoor unit

7.4.1 About mounting the indoor unit

7.4.2 Precautions when mounting the indoor unit

7.4.3 To install the indoor unit

ERGA04~08DAV3(A) + EHVZ04+08S18+23DA6V+9W7
Daikin Altherma 3 R F
4P618957-1 – 2020.03
3 Insert a rubber sheet between the cables and the outdoor unit to prevent the
cables from scratching the paint (field supply).
4 Attach the ends of the cables.
5 Tighten the cables.
When
You have to mount the outdoor and indoor unit before you can connect the
refrigerant and water piping.
Typical workflow
Mounting the indoor unit typically consists of the following stages:
1 Installing the indoor unit.
INFORMATION
Also read the precautions and requirements in the following chapters:
▪
General safety precautions
▪
Preparation
1 Lift the indoor unit from the pallet and place it on the floor. Also see
handle the indoor unit" [
2 Connect the drain hose to the drain. See
4
the drain" [ 66].
3 Slide the indoor unit into position.
4 Adjust the height of the leveling feet to compensate for floor irregularities.
The maximum allowed deviation is 1°.
4
17].
"7.4.4 To connect the drain hose to
7 Installation
|
"3.3.3 To
Installer reference guide
65