Yamaha PSR-SX600 Reference Manual page 38

7
Press the appropriate [1 ] or [2 ] button on the Rec Channel display to disable
recording.
If the Rec Channel display is not shown, press the [1 ] (Rec Ch) button.
8
Save the recorded Style (see step 8 on
NOTICE
The created Style will be lost if you change to another Style or turn off the power to the instrument without carrying out the Save operation.
 Recording to the Bass, Chord 1–2, Pad and Phrase 1–2 Channels
The procedure below applies to step 5 in the Basic Procedure on
1
From the Basic page, press [1 ] (Rec Ch) button to display the Rec Channel
display in the lower half section of the display.
2
2
Hold down one of the [3 ]–[8 ] buttons to select the desired channel as the
recording target.
If a preset Style is selected, a confirmation message appears, prompting you whether or not to delete the
already recorded data of the selected channel. Press the [+/YES] button to delete data and the selected
channel is specified as the recording target. Note that channel data other than the Rhythm channels of the
preset Style cannot be overdubbed.
3
If necessary, select a Voice, and then practice the bass line, chord backing, or phrase
to be recorded.
Press one of the [3 ]–[8 ] buttons (selected channel) to call up the Voice Selection display then select
the desired Voice. After selecting, press the [EXIT] button to return to the original display. With the
selected Voice, practice the phrase or chord backing to be recorded.
• Available Voices for recording
Any except for the Drum Kit/SFX kit Voices can be used for recording.
• Record a phrase in CM7 (for playing appropriate notes while chords change during performance)
Rules when recording a Main or Fill
Before recording the Source Pattern, determine which key you play (Source Root) and which chord type
you use (Source Chord). With the default initial settings, the Source Root/Chord
(Source Root = C and Source Chord = M7). This means that you should record a Source Pattern using a
CM7 scale, which will change according to the chords you specify during normal performance. Record
a bass line, phrase or chord backing which you want to hear when CM7 is specified. See below for
details.
• Use only the CM7 scale tones when recording the Bass and Phrase channels (i.e., C, D, E, G, A, and
B).
• Use only the chord tones when recording the Chord and Pad channels (i.e., C, E, G, and B).
NEXT PAGE
38
PSR-SX600 Reference Manual
page 36).
page 35.
2
(page 45) is set to CM7