PerkinElmer Lambda 365 Installation Instructions Manual page 5

Sam pling
W hen the tube height is less than 105 m m
1. Insert the tube in the test tube holder.
Figure 9 Inserting the test tube
W hen the tube height is m ore than 105 m m
Available tube height up to 130 mm.
NOTE:
1. To control the height adjustment plate, loosen the four screws by using a Phillips screwdriver.
Figure 10 Controlling the height adjustment plate
2. Insert the tube and set the appropriate location of the height adjustment plate so that the
inserted tube does not block the sample compartment lid from closing.
NOTE: If the tube height is more than 120 mm, it is recommended to remove the height adjustment plate.
3. After setting the height, tighten the Phillips round head screws with washer.
5
09931258D