INSYS Modem 336 LL 2D/4D 5.x Originate / Answer Manual page 72

S Registers
S12* Transmission clock of the ESC characters
Minimum pre and post run time and maximum interim time in 1/50 of seconds
between two characters. This must be observed, if the modem is supposed to de-
tect an abort sequence (usually +++).
S13* Number of dialing attempts to send a message
Bit
Bit 0 – 3
Bit 4 - 7
S14* General settings
Bit
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
S15* DTC Time Settings
The idle connection control is a function integrated in the firmware which moni-
tors the data transmission in online mode. This function prevents the modem to
stay online for an unlimited amount of time, although no data is being transmit-
ted anymore.
In the register S15, any time period between 1 and 255 seconds may be entered. If
S15 is set to 0, the idle connection control is switched off.
The timer will run immediately after the modem goes off-hook. As soon as the
timer has run out, a modem reset is performed (which will forcibly lead to the
hanging up of the modem).
72
Meaning
Number of dialing attempts
Reserved
Meaning
Reserved
Echo on inputs
Reserved
Result format
Reserved
Tone/pulse dialing
Reserved
Originate/answer
INSYS Modem 336 LL 2D/4D 5.x Originate / Answer
Range of values: 1...12
Default value: 3
S13 determines the number of attempts to send the
message.
Note: The limitation to a maximum of 12 at-
tempts is necessary for approval pur-
poses (black listing).
Command echo
Result codes:
Tone/pulse
Originate/answer
0: Echo off
1: Echo on
0: Message numbers (ATV0)
1: Message texts (ATV1)
0: Tone dialing (ATT)
1: Pulse dialing (ATP)
0: Answer mode
1: Originate mode