Table of Contents
Advertisement
INSYS Modem 336 LL 2D/4D 5.x Originate / Answer
Command
AT*X
AT&Y<n>
AT*Yx,y
ATZ<n>
<Pause> +++
<Pause>
<Pause> ****
<Pause>
Description
Terminate remote configuration
The command AT*X terminates a remote configuration.
Selection of user configuration for hardware reset
AT&Y0
For a hardware reset following the AT&Y0 command, the user default 0
(created using the AT&W0 command) is loaded into the current modem
configuration.
AT&Y1
For a hardware reset following the AT&Y1 command, the user default 1
(created using the AT&W1 command) is loaded into the current modem
configuration.
Switch outputs
x:
Port (OUT1=0, OUT2=1)
If no port is specified (x), OUT1 is used
Desired condition of the output (relay open =0, relay closed =1)
y:
Default:
AT*Y0,0
Software reset
The command causes the INSYS Modem 336 LL 2D/4D 5.x Originate / Answer to per-
form a software reset. The INSYS Modem 336 LL 2D/4D 5.x Originate / Answer will load
the default saved by the user (according to the parameter). If no parameter is specified,
the user default 0 is loaded.
ATZ0
Software reset; afterwards the user default 0 is loaded.
ATZ1
Software reset; afterwards the user default 1 is loaded.
Change from data mode to command mode (online command mode).
1 second pause before and after the entry, no Return - <CR> -. After the response OK, an
additional waiting period of 1 second for the re-entering of AT commands must be
observed.
Start of the remote configuration at the local modem
After the 4 escape characters **** were entered at the local modem (1 second pause
before and after the entry, no return - <CR> -), the remote configuration at the remote
terminal is activated. After the response OK, an additional waiting period of 2 seconds
for the re-entering of AT commands must be observed.
AT*Y1,0
AT Command Reference
65
Advertisement
Table of Contents
Need help?
Do you have a question about the Modem 336 LL 2D/4D 5.x Originate / Answer and is the answer not in the manual?
Questions and answers