Chapter 2 Specification ･････････････････････3 - Toshiba V Series Operation Manual

Chapter 2 Specification
Table 2-1 shows the FL312 module specification.
Item
Number of modules per system
Applicable physical layer
Connected controller
Communication service Cyclic transmission
Message transmission
External dimensions
Power supply External terminal
Internal current consumption
Weight
Note1: When using FL-net, the number of TL-S20 is as follows.
Number of modules for FL-net
Note2: When the controller specifies batch I/O, communication is performed in
asynchronous mode and one data synchronicity is guaranteed only up to one word
(16bits). Synchronous mode uses common memory I/O request in user program. In
this case, data synchronicity is guaranteed in request unit.
Note3: This transmission performance is the FL-net initial target performance. In order to
implement this, each transmission station must perform data transmission and
token exchange within approximately 1.5 ms after receiving a token.
6F8C1067
Table 2-1 FL312 module specification
Description
Up to 4 modules/station system
10BASE5
10BASE-T
Integrated Controller V SeriesS3
controller
Size: 8 k words + 8 k bits
Sync./Async. mode (note 2)
Transmission performance:
50 ms or less/32 units,
at 2 k word + 2 k bit (note 3)
FL-net message transmission
support
35W x 250H x 110D mm
12VDC 500 mA or less
5VDC 700mA or less
500g or less
Maximum number of TL-S20
1
2
3
4
Remark
The actual number of modules
per system depends on the
station system configuration
(Note 1)
FL312 cannot use 10BASE5
and 10BASE-T simultaneously.
Excluding protrusions
AUI supply power
28
24
20
16
3