Advertisement
Installation Instructions:
FIG 5
Next, gently close the door and align the
latch on the vehicle striker pin. Push the
door onto the striker until the latch fully
engages with two clicks. The Quadratec
tube doors are equipped with two stage
latches; please make sure that both
stages are engaging before proceeding.
(FIG5)
FIG 7
While the doors are still closed and
the latch is engaged, tighten the hinge
fasteners with a 5mm hex key and
13mm wrench. (FIG7)
For 4 Door Vehicles Only: Adjust the
door stop out until the rubber end firmly
makes contact with the body of the vehicle
(FIG8). Tighten both the jam nuts with
a 10mm wrench. Depending on your ad-
justment the jam nuts may be on opposite
sides of the bracket as shown (FIG8) or
both nuts may be installed on the inside of
the bracket to provide proper clearance.
FIG 6
If the latch is not engaging properly
you may need to loosen the latch with
a 13mm wrench and a T40 torx bit
(13mm wrench only on JK rear doors).
Adjust the position of the latch as
needed. (FIG6) Tighten all fasteners
after the adjustment is complete.
FIG 8
FIG 9
For 4-Door
Vehicles only
4
For 4-Door
Vehicles only
Advertisement
