Quadratec 12061.010 Series Installation Manual

Quadratec
Front Bumpers
Installation Manual for '76-'06 CJ-7 & Wrangler
#
PARTS LIST:
FRONT TUBULAR BUMPER - QTY 1
1 ⁄ " ZINC PLATED WASHERS - QTY 4
2
1 ⁄ "- 13 x 1 - 1 ⁄ " Grade 8 BOLTS - QTY 2
2 2
Required Tools Note: Depending on what bumper
you currently have on your Jeep
market) will determine exactly what wrench you
will need to remove and install your new
Quadratec bumper.
12061.010X, # 12061.020X,
TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE:
READ ALL SAFETY MESSAGES AND UNDERSTAND ALL
INSTRUCTIONS AND PROCEDURE NOTICES BEFORE
ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
MOUNT WINCH USING ONLY QUADRATEC APPROVED MOUNTING
PLATE. BUMPER/WINCH PLATE NOT INTENDED FOR WINCHES IN
EXCESS OF 9500LBS. LOAD LIMITS FOR YOUR BUMPER/WINCH
MAY BE LESS DEPENDING ON CONDITION OF YOUR VEHICLE
AND ATTACHMENTS. FOLLOW ALL INSTRUCTIONS, LIMITATIONS
& WARNINGS WITH YOUR VEHICLE, THIS PRODUCT, YOUR
WINCH AND SAFE WINCHING PRACTICES SUPPLEMENT.
RISK OF EYE INJURY! SAFETY GLASSES MUST BE WORN AT ALL
TIMES WHILE INSTALLING OR MAINTAINING THIS PRODUCT.
TORQUE AND RECHECK FASTENERS AFTER 250 MILES AND
FREQUENTLY THEREAFTER. INSPECT BUMPER, WINCH AND
MOUNT BEFORE USE. DO NOT USE IF DAMAGED.
CHECK STATE AND LOCAL HIGHWAY SAFETY LAWS REGARDING
PERMITTED BUMPER TYPES AND HEIGHTS.
(factory or after-
®
The Trusted Source
Tubular
®
# 12061.021X
REQUIRED TOOLS:
SAFETY GLASSES
T55 TORX HEAD SOCKET
TORQUE WRENCH
The T55 Torx wrench listed above is to remove
and re-install factory bolts on a 97-06 Wrangler.
Some Aftermarket bumpers use an oversized
Phillips Head or bolt type head.
®