Advertisement
Installation Instructions:
FIG 1
Start by locating the hinge fasteners.
Loosen the fasteners on the upper and
lower hinges slightly with a 5mm Hex
key and a 13mm wrench or socket. (FIG1)
FIG 3
Loosely install the factory door reten-
tion nuts with a T50 Torx but do not
fully tighten at this time. You may need
to wiggle the door in order to align the
hinge pins in hinges. (FIG3)
FIG 2
Align the hinge pins with the factory
door hinges of your vehicle and gently
lower the doors onto the hinges. (FIG2)
FIG 4
With a 10 mm wrench loosen the jam
nuts on the door stop and thread the
door stop in as far as it will go. (FIG4)
PLEASE NOTE THE DOOR STOP IS ONLY USED ON 4 DOOR VEHICLES.
THE DOOR STOP IS NOT USED ON 2 DOOR MODELS. PLEASE REMOVE
THE STOP AND DISREGARD REFERENCES TO THIS FEATURE IF YOU
ARE INSTALLING THESE DOORS ON A 2 DOOR VEHICLE.
3
Advertisement
