Table of Contents
Advertisement
Contents
25.3
44
Final adjustment
Tilt brake
32
The tilt brake is adjusted by inserting a 2 mm hexagon wrench through the hole in the bottom of the tilt
unit cover (33) and turning the pushrod/spring assembly grub screw (19). Adjust the tilt brake as follows
(Fig
6.9):
32.1 Turn the tilt drag knob fully counterclockwise.
32.2 Operate the tilt brake lever from the OFF to the ON position.
32.3 Brake pressure should be felt after approximately one-third of the lever travel. Turn the grub
screw (19) clockwise to decrease the amount of lever travel, counter-clockwise to increase.
32.4 Operate the tilt brake lever to the OFF position and ensure that the platform is free to move.
Pan brake
33
The pan brake is adjusted by turning the locating pin (14), accessible from under the right-hand side of
the base. Adjust the pan brake as follows
44.1
Fig 5.3 Tilt Drag Knob Adjustment
(Fig
6.5):
First
Previous
Next
Page
Page
Page
Previous
View
25
25.1
25.2
TILT_ADJ
49
Hide quick links:
Advertisement
Table of Contents
