Vinten Vector 700 Maintenance Manual page 30

Contents
Tilt brake/balance knob/centre lock
7 Remove the balance knob and associated components as follows
7.1 Carefully prise out the knob bung (29)
7.2 Remove screw (28) and washer (27). Pull off the balance knob (26) and remove drag knob boss
(25). Remove the pin (24).
7.3 Remove spring (22) and washer (21) from shaft (23).
8 To remove the tilt cover/centre lock assembly, proceed as follows
8.1 Remove three screws (10) securing the tilt cover/centre lock assembly (30-37) to the tilt back
plate (41).
8.2 Pull off the tilt cover/centre lock assembly. Slight tapping of the tilt unit cover (33) may be
required.
8.3 Remove 'O' ring (20).
9 To dismantle the tilt cover/centre lock assembly, proceed as follows
9.1 Remove screw (37) to free centre lock release lever spring (36). Remove spring.
9.2 Push out dowel (31) and remove centre lock plunger (30). Remove spring (32) from inside centre
lock plunger.
9.3 Lift centre lock release lever (34) off dowel (35).
9.4 Remove dowel (35) and two Spirol pins (12) from tilt unit cover (33) if required.
10 To remove/dismantle the tilt brake assembly, proceed as follows
10.1 Pull out the tilt brake shoe axle (11) to free the tilt brake shoe assembly (39)
10.2 Remove the tilt brake shoe assembly (39) and spring (40).
10.3 Remove the push rod/spring fork assembly (14-19).
NOTE: Do not dismantle the push rod/spring fork assembly (14-19) unless necessary.
10.4 Remove four screws (13) securing tilt back plate (41) to the mechanism housing (1). Remove tilt
back plate
NOTE: The tilt brake bell crank (8), connecting link (43) and associated components are removed
with the RH support cap assembly
10.5 If required, scrape the tilt brake reaction lining (45) off the mechanism housing (1), taking care
not to damage the surface of the casting. Clean the mating face on the mechanism housing.
10.6 Remove two Spirol pins (12) and two grubscrews (42) from tilt back plate (41) if required.
(Fig
(Para 13).
First Previous Next
Page Page Page
(Fig 6.9):
(Fig 6.9):
(Fig 6.9):
6.9):
Previous
View
30