Vinten Vector 700 Maintenance Manual page 25

Contents
14.3 On the underside of the head, remove three screws
14.4 Operate the pan brake lever
14.5 If brake pressure is not felt after approximately one-third of the lever travel, turn the locating pin
(5) clockwise until this is achieved.
14.6 Operate the pan brake lever
14.7 Refit cover plate
Repositioning the wedge adaptor
15 The wedge adaptor is secured by four cap head screws which pass through the wedge adaptor into the
sliding plate.
WARNING!: Over-long screws will prevent the sliding plate from operating. Always use
the screws provided (M6 x 30mm).
(4)
(3)
(7) from the OFF to the ON position.
(7) to the OFF position and ensure that the head is free to rotate.
(3) and secure with three screws (4).
Fig 4.5 Repositioning the wedge adaptor
First Previous
Page Page
(4) securing cover plate (3).
Next Previous
Page View
(1)
(2)
V700 RIT
25