Vinten Vector 700 Maintenance Manual page 29

Contents
4 To dismantle the platform assembly, proceed as follows
4.1 Remove two screws (22) securing tilt brake centre (21) and brake disc (tilt) assembly (20) to the
platform (28). Pull out two Spirol pins (3).
4.2 Release the sliding plate clamp (24). Using the platform adjustment knob (15), move the platform
slide (1) to gain access to each stop screw (7). Remove both stop screws. Turn the adjustment knob
until rack (29) disengages from worm drive shaft (6). Slide out the platform slide (1).
4.3 If required, pull out three Spirol pins (30) to release the rack strip (29), which may then be slid out
of the platform slide (1).
4.4 Remove slide clamp cover (25). Slacken screw (23) and unscrew slide clamp screw (26).
Remove slide clamp (19) and slide clamp lever (24) from platform. Remove screw (23) from slide clamp
lever.
4.5 Remove platform adjustment cover (5).
4.6 Remove screw (16) securing platform adjustment knob (15) to pinion (12).
4.7 Remove two screws (14) securing bearing bracket (13) to platform. Remove bearing bracket
complete with pinion (12).
4.8 Remove two screws (18) securing shaft support (17) to platform.
4.9 Remove adjustment shaft assy (6) from platform.
4.10 Remove self-adhesive PTFE strip (11) from platform
4.11 Remove buffer (10) from platform. On Vector 700H, remove front stop bung (9) if required.
4.12 Remove three screws (2) securing each serrated disc (4) to platform. Remove three Spirol pins
(3) from each location.
Spring-Loaded Flap
5 To remove the spring-loaded flap, proceed as follows
5.1 Hold the flap (6) open and push the pins (4) inwards until the flap pins (2) are clear of the
mechanism housing (1).
5.2 Pull the flap clear of the mechanism housing.
6 To dismantle the spring-loaded flap, proceed as follows
NOTE: The flap springs (3, NI) are handed. Note orientation for assembly.
6.1 At each side of the flap, remove Spirol pin (4) to release flap pin (2), spring (5) and flap spring (3,
NI).
First
Page
(Fig 6.10):
(Fig 6.9):
(Fig 6.9):
Previous Next Previous
Page Page View
29