Vinten Vector 700 Maintenance Manual page 24

Contents
Pan and tilt brake adjustment
12 Following bedding-in, the pan and tilt brakes may require adjustment. The pan and tilt brakes should be
set so that the brakes begin to be applied after approximately one-third of the lever travel
13 The tilt brake is adjusted by inserting a 2 mm hexagon wrench through the hole
tilt unit cover and turning the grub screw (1). To adjust the tilt brake, proceed as follows:
13.1 Operate the tilt brake lever
13.2 If brake pressure is not felt after approximately one-third of the lever travel, turn the grub screw
(1) clockwise until this is achieved.
13.3 Operate the tilt brake lever
14 The pan brake is adjusted by turning the locating pin (5). To gain access to the pin it is necessary to
remove the payload from the head, remove the head from its mounting and remove a cover plate
underside of the head. To adjust the pan brake, proceed as follows:
WARNING!: Remove the payload before adjusting the pan brake.
14.1 Remove the payload from the head.
14.2 Remove the head from its mounting.
(7)
(6)
(5)
(4)
(6) from the OFF to the ON position.
(6) to the OFF position and ensure that the platform is free to move.
Fig 4.4 Pan and Tilt Brake Adjustment
First Previous Next
Page Page Page
(Fig 4.4).
(2) in the bottom of the
(3)
Previous
View
from the
(1)
(2)
(3)
V70BRAKE
24