Vinten Vector 700 Maintenance Manual page 33

Contents
13.20 The lower drive arm and the horizontal track arm (21, 17) are now freed from the mechanism
housing. To separate these components, support them carefully and drive in two horizontal track arm
pins (16), taking care not to damage the bearings in the horizontal track arm (17). Note the position of
and retain all shims (18).
13.21 In the mechanism housing, remove bearings (12) from central hubs if required. Remove rear tilt
buffer (20) if required.
Balance adjuster assembly (Vector 700)
NOTE: The balance adjuster was improved at Serial No. 785. The earlier balance adjuster
(3354-14) should be replaced with the redesigned balance adjuster (3554-54).
14 To dismantle the balance adjuster assembly, proceed as follows
14.1 Remove Spirol pin (15) securing bevel gear (14) to adjuster shaft (11). Slacken grubscrew (8)
and pull gear off shaft.
14.2 Remove 'E' clip (12) from shaft.
14.3 Pull bush (13) out of housing (7) if required.
14.4 Turn adjuster shaft (11) to position carriage (9) in mid position. Manipulate shaft and carriage out
of housing (7).
14.5 Unscrew adjuster shaft (11) from carriage (9). To remove track rollers (1), shims (2), track wiper
mouldings (3) and track wiper outers (4) from carriage, undo grub screws (8) and pull out roller axles (5,
10). Note orientation of roller axles. Separate track wiper mouldings (3) and track wiper outers (4) if
required.
14.6 Drive out lift-off stop pin (16) if required.
14.7 Pull out the bearings (6) if required.
Balance adjuster assembly (Vector 700H)
NOTE: The balance adjuster was improved at Serial No. 785. The earlier balance adjuster
(3354-44) should be replaced with the redesigned balance adjuster (3554-55).
15 To dismantle the balance adjuster assembly, proceed as follows
15.1 Remove Spirol pin (16) securing bevel gear (15) to adjuster shaft (11). Slacken grubscrew (8)
and pull gear off shaft.
15.2 Remove 'E' clip (13) from shaft.
15.3 Pull bush (14) out of housing (7) if required.
15.4 Turn adjuster shaft (11) to position carriage (9) in mid position. Manipulate shaft and carriage out
of housing (7).
First Previous
Page Page
(Fig 6.7)
(Fig 6.8)
Next Previous
Page View
33