Table of Contents
Advertisement
Installing
Follow steps 2 to 4 with doors that have two glass panels.
When installing, ensure that the "right above" inscription on the
lower left part is inverted.
Insert the glass panel by tilting it backwards (Figure A).
1.
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Fault
The oven does not work.
The display panel shows
The oven does not heat or it is not possi-
ble to set the selected type of heating.
The oven does not heat up. The tempera-
ture display shows a small frame.
After pushing the button
s
panel displays
Ÿ©
The display shows
.
"‰
Error messages
When the display panel shows an error message with
the
button. The message will disappear. The set time
0
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
Error message Possible cause Solution/advice
A button has
"‹‚‚
been pressed
for too long or
has got stuck.
:
Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical
Assistance Service.
Possible cause
The fuse has blown.
Power cut.
‹
:
‹‹
The heating type is not recog-
nised.
The oven is in demo mode.
The side walls inside the oven are
, the display
not self-cleaning. The clean func-
tion cannot be used.
The automatic shut off function is
activated.The oven will stop heat-
ing.
Press all of the buttons one
by one. Check if any button
is stuck, covered or dirty.
Insert the upper glass panel on both mounts by tilting it
2.
backwards. Ensure that its smooth surface is facing
outwards. (Figure B)
Fit and tighten the cover.
3.
Refit the oven door.
4.
Once the glass panels have been correctly fitted, the oven is
ready to use.
Solution/advice
Check the condition of the fuse in the fuse box.
Set the time once more.
Reprogram.
Disconnect the fuse in the fuse box and connect it
again after at least 20 seconds. Within the next
2 minutes, hold the button
the indicator no longer displays the square.
The clean function can only be programmed with
the button
self-cleaning side walls and the clean function is
activated in the basic settings. See the Clean func-
tion and Basic settings chapters.
Press any button.
, press
"
h
in for 4 seconds until
if the appliance is equipped with
s
17
Advertisement
Table of Contents
