Setting The Track - TechniSat DIGITRADIO 360 CD Instruction Manual

> Close the CD compartment using the EJECT (13) button on the device or OPEN/CLOSE (17) on the
remote control. The CD is read and this is shown on the display.
After the reading process has finished the first track is played. The track number of the current track as well as
the playing time appear on the display. With MP3 CDs, the album number also appears.
If the CD is inserted incorrectly or if the CD appears to be faulty, "No CD" appears on the display.
If an MP3-CD is inserted, the MP3 warning appears on the display.
Do not perform any operation until the CD content has been completely read, to ensure that all the
required information on the CD has been read. With MP3 CDs in particular, this process can take
some time.
To insert/remove the CD, please hold it by the edge.
> Playback can be paused by pressing the Play/Pause button on the device or 4/;(31),(the playing time
flashes on the display), and continued by pressing it again.
> Playback is stopped by using the STOP (6) button on the device or < (32) on the remote control. The
total number of tracks appears on the display.
Always stop the playback prior to removing the CD.
If there is no playback, the

8.4 Setting the track

> If required, select the categorisation or folder and the subfolder it contains until you reach the track you
want in order to play it.
> You can select folders/albums using the FOLDER- or FOLDER+ buttons (41, 28).
> You can use the FORWARD (9) or BACK (10) buttons on the device or the TUNING s/97 or TUNING
r/8: (45, 25) buttons on the remote control to skip to the next or previous track respectively.
The display shows the respectively set track number.
DIGITRADIO 360 CD switches to standby after 15 minutes.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
41 41