Time Setting; Alarm - TechniSat DIGITRADIO 360 CD Instruction Manual

11.2 Time setting

If a DAB signal is being received, the time is synchronised automatically and the correct time is set. If the time
is not set automatically, proceed as follows:
> Switch the device to standby.
> Press the CLOCK (19) button on the remote control. The hour display flashes:
> Use the TUNING s/97 or TUNING r/8: (45, 25) buttons on the remote control to set the current
hour.
> Confirm with CLOCK. The minutes flash on the display.
> Use the TUNING s/97 or TUNING r/8: buttons to set the current minute.
> Confirm with CLOCK. The time is now set.
After approx. 5 seconds without pressing any buttons the menu closes without any change.

11.3 Alarm

The timer switches the device on according to the set alarm time.
> Press the TIMER (20) button on the remote control and hold it down. SWITCH ON appears on the
display. The hours flash.
> Use the TUNING s/97 or TUNING r/8: (45, 25) buttons on the remote control to set the hour.
> Confirm with TIMER. The minutes flash on the display.
> Use the TUNING s/97 or TUNING r/8: buttons to set the minute.
> Confirm with TIMER.
> SWITCH OFF appears on the display to set the switch-off time. The hours flash.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
47 47