Power Led And Power Button - EMC2 Data Domain DD9500 System Installation And Upgrade Manual

Figure 49 Power LED and power button
1. Power LED
2. Power button
5.
Note
The initial username is sysadmin and the initial password is the system serial
number.
Log into the Data Domain console using the sysadmin username.
localhost.localdomain login: sysadmin
6. Enter the default password, which is the system serial number (SSN). The SSN is on
the attached tag on the rear panel of the system. See the rear panel of the DD9500
system for the SSN tag.
Password: system_serial_number
Note
Configuring an HA pair sets the system password on the standby node to match the
system password on the active node, however, that synchronization is not set until
the HA configuration is complete. If the HA configuration fails, or if there is a need to
access either node before the HA configuration is complete, use the serial number of
each node as the password.
Note
If you enter an incorrect password four consecutive times, the system locks out the
specified username for 120 seconds. The login count and lockout period are configurable
and might be different on your system. See the EMC Data Domain Operating System
Administration Guide and the EMC Data Domain Operating System Command Reference
Guide for setting these values.
Configure System For Use
Enable administrative communication
71