Maintenance; Care And Cleaning; Exterior Surfaces; Interior Surfaces - Hussmann microSC GSVM A Series Installation & Operation Manual

P/N 3109358_B
To reduce the risk of fire, electrical shock or
injury when cleaning this merchandiser:
• Unplug the merchandiser before cleaning;
• Keep all liquids away from electrical and
electronic components;
• Do not use any mechanical device or other
means to speed the defrost process, except
as recommended by the manufacturer.

CARE AND CLEANING

Long life and satisfactory performance of
any equipment is dependent upon the care it
receives . To ensure long life, proper sanitation
and minimum maintenance costs, these
merchandisers should be thoroughly cleaned,
all debris removed and the interiors washed
down, weekly .

Exterior Surfaces

The exterior surfaces must be cleaned with a
mild detergent and warm water to protect and
maintain their attractive finish . n
AbrAsive cleAnsers or scouring pAds

Interior Surfaces

The interior surfaces may be cleaned with most
domestic detergents, ammonia based cleaners
and sanitizing solutions with no harm to the
surface . Self contained models empty into a
limited capacity evaporation pan, which will
overflow if excess water is used in cleaning .

DO NOT Use:

Abrasive cleansers and scouring pads, as these
will mar the finish or coarse paper towels on
coated glass . DO NOT use ammonia-based
cleaners on acrylic parts .
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.

MAINTENANCE

Solvent, oil or acidic based cleaners on any
interior surfaces .
Do not use high pressure water hoses .
DO NOT flood merchandiser with water .
n
ever introduce wAter fAster thAn the
wAste outlet cAn remove it
Self contained models empty into an evaporation
pan that will overflow if too much water is introduced
during cleaning.
Do Use:
Remove the product and all loose debris to
avoid clogging the waste outlet . Store product
in a refrigerated area such as a cooler . Remove
only as much product as can be taken to the
cooler in a timely manner .
Disconnect electrical power before cleaning.
ever use
.
Thoroughly clean all surfaces with soap and
hot water . d
pressure hoses to wAsh the interior
t
hese will destroy the merchandisers
sealing causing leaks and poor performance
Lift hinged fan plenum for cleaning . Hook
chain in rear panel to secure plenum during
cleaning . Be sure to reposition the fan plenum
after cleaning merchandiser . Take care to minimize
direct contact between fan motors and cleaning
or rinse water .
Allow merchandisers to dry before resuming
operation . After cleaning is completed, turn on
power to the merchandiser .
Product will be degraded and may spoil if
allowed to sit in a non-refrigerated area.
o not use steAm or high wAter
GSVM-A Open Vertical Merchandisers
4-1
.
.
'
.