Troubleshooting Light Guide; Gsvm Accessories - Hussmann microSC GSVM A Series Installation & Operation Manual

5-6
service
PROBLEM
Lights won't start
Lights flicker
GSVM-A ACCESSORIES
The following is a description of the various
accessories available for the GSVM-A .
Caster Kit — Consists of 5 in . braking casters,
which screw in to the standard threaded holes
in the four corners under the cage occupied by
the standard leg levelers . The kit will add
5 5 / in . of height to the case .
8
Leg Kit — The legs also go into the same holes
as the standard levelers, which will have to be
removed . The legs are adjustable and will add
5
5 / in . to the height of the case . The skirt kit
16
requires the use of these legs .
Four-sided Skirt Kit — This is a four-sided
skirt that encloses the open area under the
merchandiser when the leg kit is used . The
skirt kit clamps to the legs .
P/N 3109358_B

TROUBLESHOOTING LIGHT GUIDE

U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com
SOLUTION
1 . Check light switch
2 . Check continuity to power supply
3 . Check voltage
1 . Light bar replacement may be necessary
2 . Check voltage
Wrap-Around Bumper Kit — This bumper
replaces the standard front bumper and wraps
around both sides of the merchandiser at the
standard height of 22 inches to the centerline
of the 2 1 / in . wide bumper .
4
Colored Accent Panel — This panel can be (a .)
the top front panel over the product, (b .) the
panel behind the bumper, or (c .) the access
panel below the bumper panel, or any
combination of these .
Shelf end Trim Kit — Consists of four painted
steel ends for the standard 13 in . and 15 in .
shelves . This trim conceals and protects the
exposed ends of the shelves . The trim kit
attaches by two snap fasteners supplied with
each trim piece for the GSVM-4060A model .