YASKAWA IM 053MT Manual page 54

Deployment
Access to the Ethernet coupler > Web server
Tab: Parameter
Parameter Data type
Link monitoring BOOL
Communication UINT_32
timeout [ms]
IO cycle [µs] UINT_32
Tab: Diagnosis
Tab: Security
Tab: IP
54
Here you can change the current parameters of the IM 053MT.
To change the parameters, the IM 053MT should be in BASP status.
Area
TRUE/FALSE
n 0 ... 30000
n 0
n 1000
n 2000
n 4000
n 8000
10000
n
n Link monitoring
– As soon as both Ethernet cables are pulled with enabled Link monitoring, the
communication is finished by the IM 053MT, BASP (Befehls-Ausgabe-Sperre, i.e.
command output disable) is activated and this is indicated with flashing SB LED.
Link monitoring reacts only when both Ethernet cables are pulled.
n Communication timeout
– At Communication Timeout [ms] you can specify a timeout value for Ethernet
communication in ms.
– If there is no Modbus/TCP communication for the specified time, BASP is set on
the System SLIO bus.
– With the value 0, you can deactivate the time monitoring.
n IO cycle
– With IO cycle, you can specify the cycle for the System SLIO bus within which the
I/O image is to be refreshed.
– With the value 0 you can set the maximum possible cycle time (no delay).
n Configuration State
– Deviations between the setpoint and actual configuration are shown here
(OK: no deviation).
n Diagnosis Entries
– Here all pending diagnostic messages are shown.
n Diagnosis Buffer
– Here the content of the diagnostics buffer is listed.
All functions for the writing access to the Ethernet coupler can be secured by a password.
Here you may assign to your Ethernet coupler IP address data. For valid IP address data
please contact your system administrator.
Default value Description
FALSE Link monitoring Ethernet
0 Timeout Ethernet communication
1000 System SLIO bus cycle
HB300 | IM | 053-1MT01 | en | 19-40
VIPA System SLIO