Table of Contents
Advertisement
®
ProMinent
5.1.2
Assembly
IMPORTANT
•
The system must be assembled according to the accompanying data sheet.
•
Leave sufficient space to carry out maintenance work.
Please refer to the accompanying data sheet for the amount of space required.
Use the mounting materials provided to secure the radiation chamber to the wall or a
suitable frame in a horizontal position.
5.1.3
Attaching the Warning Sign
NOTE
Stick the self-adhesive warning sign provided onto the radiation chamber so that it is
clearly visible.
5.1.4
Hydraulic Connections
IMPORTANT
•
Hydraulic connection of the radiation chamber should be carried out in accordance
with current general guidelines and the installation regulations in your country.
•
Use UV-resistant material for hydraulic connection. PVC installation material may only
be used at a safe distance from the radiation chamber.
•
For applications in which high levels of disinfection are required (e.g. the disinfection of
drinking water) there must be no interruption of the flow in the event of a fault (e.g.
booster pump disconnection):
Install an automatic stop valve after the radiation chamber and connect it to the control
system.
The stop valve must close automatically to ensure that the flow is interrupted in the
event of a supply voltage failure.
NOTE
•
Valves should be fitted before and after the radiation chamber so that it can be shut off
for maintenance purposes.
•
Fireproof taps suitable for taking microbiological samples should be fitted upstream
and downstream from the radiation chamber.
5.2
Control Cabinet
5.2.1
Installation
The control cabinet should be installed so that the lamp and sensors can be connected using
the cables provided.
•
Use the clamp to secure the cable conduit containing the lamp connection cable, the earth
wires, the sensor connection cables and the wiper motor in the middle of the radiation
chamber.
NOTE
To prevent water from dripping into the end of the cable conduit, if necessary, provide
appropriate protection for the end of the conduit and/or install it so that the opening is
facing downwards.
Assembly and Installation
Page 23
Advertisement
Table of Contents
