Table of Contents
Advertisement
Version
Default setting
In operating mode
In programming mode
®
ProMinent
4
Controller
As electronics and software are continuously being improved, the version number has been
introduced as a means of identifying the system. This should be given in the event of a query or
complaint.
The controller system of the Dulcodes M UV system is preset at the factory. Unless calibrating
the sensor, it is not usually necessary to change the settings.
NOTE
The settings can only be changed if the UV system has been switched off.
Exceptions: sensor calibration, setting the lamp output and triggering a wiper cycle.
4.1
Display
The system has a graphical display.
It indicates the operating status.
Flashing arrows and displays are used to issue a warning.
A flashing error message indicates a fault.
The numerical values and settings that can be changed are indicated as flashing text.
NOTE
If none of the keys are pressed for 5 minutes, the display returns to the normal operating
status display automatically.
Controller
Page 7
Advertisement
Table of Contents
