Operation - Winco POP-8B Operating Instructions Manual

Operation

1. Plug in the power cord.
2. Make sure the kettle is installed in its upright and locked position, and there are no obstructions in the kettle.
3. Turn on the power, stirring motor and heater switch.
4. Allow kettle to preheat for 5 to 6 minutes.
5. Open the lid and pour in oil and seasonings.
DO NOT add butter in kettle at any time while heating or when popcorn is popping.
If using butter, it should only be applied AFTER all kernels have popped and popcorn is removed from kettle.
6. Add popcorn kernels and close lid.
NOTE: Close the lid to prevent uncooked kernels and hot oil from ejecting out of the kettle.
7. Popcorn will start popping, overflowing out of the kettle into the tray below.
8. Once popping has stopped, open the lid and turn kettle to dump out remaining popcorn (there may be some un-popped kernels).
9. Repeat steps 5 through 8 to make more as needed.
NOTE: Power to the kettle must be turned off when it is not in use in order to maintain efficiency.
5