Cleaning, Care & Maintenance; Safety - Winco POP-8B Operating Instructions Manual

Cleaning & Maintenance
Before using this equipment it must be cleaned and dried
thoroughly. Clean all surfaces before use. Failure to clean
surfaces before using the unit could cause food contamination.
Always unplug the unit after every use and before cleaning. Unplug the unit when
not in operation.
Start by removing any excess kernels and debris by wiping toward the crumb
tray openings. After the inside has been wiped clean, remove the crumb tray and
discard any debris. It is recommended to clean the crumb tray prior to reinserting it into
the unit.
The interior popcorn maker should be cleaned after each use with a cloth and warm,
soapy water. The exterior of the unit may be cleaned by carefully wiping with a
damp cloth.
Warning: The cooking surface of the kettle and the bottom floor
of the unit will be hot after use. Exercise caution when handling
cooking utensils and cookware.
The kettle is removable from this unit, but it is not intended to be washed in the
dishwasher or immersed in water. Please allow kettle to cool before attempting to
clean. After completely cooled, remove the kettle from unit by disconnecting the
plug, then unhinging from its support. Use a cloth with warm, soapy water to clean.
Do not immerse the device completely in water for any reason. DO NOT use a
pressure washer to clean.
After cleaning, ensure that the kettle is plugged in correctly when reinstalling for
proper operation.
NOTE: Proper cleaning instructions must be followed; otherwise,
operation of the unit may be seriously impaired. Do not wash
parts in an automatic dishwasher.
WINCO® authorized service personnel must perform any other servicing.

Safety

SAFETY PRECAUTIONS
Before installing and operating this equipment be sure
everyone involved in its operation are fully trained and
aware of all precautions. Accidents and problems can
result from a failure to follow fundamental rules and
precautions.
• A WINCO® Approved Recommended Qualified Service Technician should carry
out repairs if necessary. Do not remove any components or service panels on
this product.
• Allow the unit to cool down after use before dismantling for cleaning; the
unit will be too hot to handle immediately after use.
• Before cleaning, switch power OFF and disconnect power cord from the
outlet.
• Do not immerse unit in water or use hose to clean.
Ne jamais immerger l'appareil dans l'eau ni utilisez un jet d'eau pour
le nettoyer.
• If the power cord is damaged, it must be replaced by a WINCO® Approved
Recommended Qualified Service Technician in order to avoid a hazard.
6
Fuse Replacement:
1. Make sure the unit is off, unplugged, and cooled down.
2. Open doors and remove metal drop door.
3. Remove the screws metal tray.
4. Remove screw and fuse box cover.
5. Untwist the ties holding the fuse holder and slide fuse holder up.
6. Open fuse holder. Remove old fuse and place in new fuse.
Note: Use 15 amp buss fuse
7. Reassemble the unit.