Operation - Winco KATTEX TTS-188 Manual

INSTALL TABLE STOP (OPTIONAL)
1. Remove the screw from base of the Tomato Slicer.
2. Attach the table stop to the base of the Tomator Slicer by
reconnecting the screw.
3. Secure the table stop to table with another screw (not
inluded).
Note: Check the tension of the blades prior to each use to
ensure they are tight.
1. Pull the handle towards you and carefully place the tomato
or other produce onto the slide board between the pusher
plates and the blades.
WARNING: THE BLADES ARE VERY SHARP.
PLEASE USE CAUTION WHEN HANDLING
2. Withdraw your hand. With one quick and seamless motion,
push the handle towards the blades and catch the tomato
in your hand or a container.
3. Remove the sliced tomato from the slide board and repeat
the procedure as desired.
If the unit fails to properly operate during its first use, call Winco customer service at 973-295-3899 or
email at equipservice@wincous.com.
DO NOT send unit to WINCO without first contacting our customer service department.
4
PREPARATION

OPERATION

Screw not
included