BEFORE OPERATING ANY EQUIPMENT, READ AND FAMILIARIZE YOURSELF WITH THESE USE AND SAFETY INSTRUCTIONS Congratulations on your purchase of this WINCO® commercial equipment. WINCO takes pride in the quality of its products. When used as intended and with proper care and maintenance, you will experience years of reliable operation from this equipment.
Introduction Congratulations on the purchase of your WINCO® machine. Please take the time to carefully read through this manual to ensure the machine is operated and maintained properly, to ensure the best possible performance from this product for many years.
• POP-8B or POP-8R plastic and cardboard, from the unit. WINCO prides itself on quality and service, ensuring that at the time of 2. Clean any glue residue left over from the plastic or tape. packing, all products are supplied fully functional and free of damage.
The outlet to which this plug is connected must be properly grounded. If the 6. The use of accessory attachments not recommended by WINCO receptacle is not the proper grounding type, contact may cause fire, electric shock or injury.
Operation 1. Plug in the power cord. 2. Make sure the kettle is installed in its upright and locked position, and there are no obstructions in the kettle. 3. Turn on the power, stirring motor and heater switch. 4. Allow kettle to preheat for 5 to 6 minutes. 5.
Ne jamais immerger l'appareil dans l'eau ni utilisez un jet d'eau pour le nettoyer. • If the power cord is damaged, it must be replaced by a WINCO® Approved Recommended Qualified Service Technician in order to avoid a hazard. 7. Reassemble the unit.
Assembly Instructions - Popcorn Cart (optional) MODEL: POP-8RC CONTENTS 14 x Screws 2 x Hand Rail Brackets [M10-32x5/16] 1 x Square Cross Bar 4 x Screws [M4-0.7x10mm] 1 x Axle 2 x Long Square Poles 2 x Jam Nuts 1 x Cart Body 2 x Axel Washers 2 x Short Square Poles 1 x Hand Rail...
Kettle Heating Switch Kettle Heating Switch This circuit diagram has been provided to assist qualified electricians; only WINCO service agents or qualified electricians should carry out repairs if required. Do not remove any components or service panels on this product.
Troubleshooting If your WINCO® Equipment does not operate properlly, please check for the following problems/solutions prior to placing a service call. PROBLEM POSSIBLE CAUSE RECOMMENDED SOLUTION Check power supply cord is correctly plugged in Power supply and outlet is working...
18 months from actual factory shipment date, whichever date occurs first. DO NOT send unit to WINCO® without first contacting our customer service department. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, WHETHER EXPRESSED OR IMPLIED.
Need help?
Do you have a question about the POP-8B and is the answer not in the manual?
Questions and answers