Table of Contents
Advertisement
2.3
LAN: Ethernet Connector
UNO-2362G is equipped with one Gigabit LAN controller. The controller chip used is
the Realtek 8111E Ethernet controller with Marvell 88E6172 Giga Ethernet switch
with daisy chain technology that is fully compliant with IEEE 802.3u 10/100Base-T
CSMA/CD standards and IEEE 802.3ab specification for 1000Mbps Ethernet. The
Ethernet port provides two standard RJ-45 jacks on board, and LED indicators on the
front side to show its Link (100Mbps orange LED, 1000Mbps green LED) and Active
(flashing green LED) status.
2.4
Power Connector
The UNO-2362G comes with a Phoenix connector that carries 24V
input, and features reversed wiring protection. Therefore, it will not cause any dam-
age to the system by reversed wiring of ground line and power line. Please refer to
Appendix A.5
2.5
USB Connector
The USB interface supports Plug-and-Play, which enables users to connect or dis-
connect a device whenever you want, without turning off the computer. UNO-2362G
provides four connectors for USB interfaces, which enables Plug-and-Play and hot
swapping for up to 127 external devices. Two of six connectors are compatible with
USB 3.0 device but only with USB 2.0 speed. The USB interface complies with USB
EHCI, Rev. 2.0. The USB interface can be disabled in the system BIOS setup. Please
refer to Appendix A.6 for its pin assignments.
2.6
DisplayPort/HDMI Display Connector
The UNO-2362G provides a DisplayPort/HDMI controller for a high resolution inter-
face. UNO-2362G supports up to full HD resolution for two independent displays.
9
UNO-2362G User Manual
external power
DC
Hide quick links:
Advertisement
Table of Contents
