Omron BU5002R Instruction Manual page 48

2 Installation and connection
2-3 Connecting the equipment
1.
2.
48
Remove 1 M3 screw and detach the terminal block cover.
<BU5002R>
There is a cap attached to the cable clamp of the terminal block cover, so remove
the cap by pressing with a screwdriver or the like, to form a hole through which
the wires can pass.
Pass the wires to be connected through the cable clamp hole on the terminal
block cover. (See Figure 1)
If the wires are difficult to pass, turn the plastic part on the cable clamp
counterclockwise to loosen it.
Crimp the specified round terminal onto each wire and tighten it using the screw
on the terminal block. (See Figure 2)
Figure 1
<BU5002R>
Figure 2
Crimp the round terminal onto the wire rod to be connected to the
terminal block.
BU5002R:
BU3002RH:
<BU3002RH>
<BU3002RH>
For M5 screw
For M4 screw
BU5002R/BU3002R/BU3002RH