Network Cable Waterproof Accessory Installation - HIKVISION DS-2CD23 Series Quick Start Manual

2.3

Network Cable Waterproof Accessory Installation

Purpose
If the camera is installed outdoors, you can use the waterproof accessory for the network cable
after the camera is secured on the installation surface.
Table 2-1 Components
No. Components
1 Camera's Network Interface Socket
2 O-Type Gasket
3 Network Plug
4 Waterproof Endcap
5 Waterproof Rubber Gasket
6 Lock Nut
7 Network Cable from Router/Switch
1. Feed the plugless network cable ⑦
(rubber gasket inset ridge must face waterproof endcap), and the waterproof endcap ④
order.
2. Crimp an RJ-45 network plug ③
pairs of wires in correct order.
3. Place the O-type gasket ②
4. Insert the network plug ③
5. Insert the waterproof rubber gasket ⑤
⑥ with the waterproof endcap ④ ⑥ ⑥ ⑥
6. Align the snap on the waterproof endcap ④
interface socket ①
interface socket ①
QSG DS-2CD23xxxx-xx Turret 051420NA
Figure 41, Waterproof Accessory Components
⑦ ⑦ ⑦ through the lock nut ⑥
③ onto the end of the cable, taking care to insert the twisted ③ ③
② onto the end of the camera's network interface socket ①
② ②
③ into the camera's network interface socket ①
③ ③
⑤ into the waterproof endcap ④
⑤ ⑤
④ . ④ ④
① , and then secure the waterproof endcap ④
① ①
① to finish installation.
① ①
⑥ , waterproof rubber gasket ⑤ ⑥ ⑥
④ with the notch on the camera's network ④ ④
④ to the camera's network
④ ④
⑤ ⑤ ⑤
④ in
④ ④
① .
① ①
① .
① ①
④ , and secure lock nut
④ ④
28