Table of Contents
Advertisement
6. Connect the corresponding power/network cable. Refer to section 2.3 for waterproof
accessory installation if the camera is installed outdoors.
7. Install the camera and the enclosure to the mounting base, adjust the surveillance
angle, and fix the trim ring.
NOTE:
Refer to the specific camera type's corresponding ceiling mounting steps.
Pendant Mounting
A pendant mounting bracket is not included in the package. You must purchase one
separately in advance if you use this mounting method.
1. Mark the screw holes on the desired mounting location.
2. Drill three screw holes for expansion bolts.
3. Route the cables and fix the pendant mounting bracket to the ceiling.
QSG DS-2CD23xxxx-xx Turret 051420NA
Figure 35, Fix Mounting Base
Figure 36, Wall Mounting
25
Advertisement
Table of Contents
