HIKVISION DS-2CD23 Series Quick Start Manual page 16

Network turret cameras

Hide thumbs Also See for DS-2CD23 Series:

Table of Contents

NOTE:

There are two cable outlet methods. One is to route the cables through the cable

hole, and the other is to route the cables through the side outlet shown below.

NOTE:

Three side outlets on the enclosure are selectable, which makes routing the cables

easier instead of drilling a cable hole on the ceiling. Use a plier to remove the plastic,

and route the cables through the hole.

3. Fix the mounting base to the ceiling with the supplied expansion screws.

4. Connect the corresponding power/network cable.

5. Install the camera along with the enclosure to the mounting base by anticlockwise

rotating the camera.

6. Rotate the enclosure to adjust the pan angle; rotate the camera to adjust the tilt

angle.

QSG DS-2CD23xxxx-xx Turret 051420NA

Figure 15, Side Outlet

Figure 16, Secure the Camera to the Ceiling

Table of Contents