HIKVISION DS-2CD23 Series Quick Start Manual page 13

NOTE: Three side outlets on the enclosure are selectable, which makes routing the cables
easier instead of drilling a cable hole on the ceiling. Use a plier to remove the plastic,
and route the cables through the hole.
3. Affix the mounting base to the ceiling with the supplied expansion screws.
4. Connect the corresponding power/network cable, and then install the camera to the
mounting base with the supplied screws. Rotate the camera to secure it.
5. Adjust the Lens.
1). Loosen the lock screw.
QSG DS-2CD23xxxx-xx Turret 051420NA
Figure 8, Secure the Mounting to the Ceiling
Figure 9, Secure the Camera to the Mounting Base
13