Epilog Laser Epilog Fusion CO2 Manual page 9

Step 9: Align red dot to burn
Use the adjustment screws on the Red Dot Pointer Mount to move the Red Dot
Pointer to the burn mark on the tape.
Once the Red Dot Pointer is aligned with the burn mark on the tape in Position 4,
it will accurately represent the path of the Cutting Laser for the rest of the alignment.
You may now remove the masking tape from the Alignment Target.
Laser Alignment
Fusion CO2
Revision Date: 10/10/2013
Marks simulated for photo
pg. 9 of 18