Epilog Laser Epilog Fusion CO2 Manual page 10

Procedure B: Aligning the laser
Step 1: Remove the left hand panels.
With the engraver powered on. Remove both the Left side Access Panels to gain
access to the mirrors. There are two black Panel Locks per panel holding them in place.
Using a 5/32" Allen wrench, turn the black Panel Locks ¾ of a turn counterclockwise.
Place the panels aside.
Step 2: Remove upper mirror access panel
Using the #1 Screwdriver, remove the Upper Mirror Access Panel.
Laser Alignment
Fusion CO2
Revision Date: 10/10/2013 pg. 10 of 18