Epilog Laser Epilog Fusion CO2 Manual page 18

Step 7:
Use the adjustment screws on the Carriage Mirror to move the Red Dot Pointer
back onto the center of the target.
Step 8:
Using the joystick on the engraver's keypad, bring the bed back up until the
display reads around 0.000.
Step 9:
Repeat [Step 4]
Red Dot moving on the Alignment Target.
Conclusion
If you encounter any problems please contact Epilog Tech Support at (303) 215-9171.
Laser Alignment
Fusion CO2
Revision Date: 10/10/2013
through [Step 8] until you can rise and lower the table without the
pg. 18 of 18