Advertisement
Step 5: Make burn
Use the Joystick on the engraver's keypad to move the Lens Carriage to Position
4 on the bed.
Step 6: Make burn
To fire the laser in Jog mode, Depress the Fire Laser key (indicated by Arrow in
picture below) and move the Joy stick to the left or the right. This will need to be done
fairly quickly as it takes little power to burn the masking tape.
If you cannot get a burn in this position, please contact Epilog technical support.
Laser Alignment
Fusion CO2
Revision Date: 10/10/2013
4
Burn simulated for photo
pg. 7 of 18
Advertisement
