Epilog Laser Epilog Fusion CO2 Manual page 5

Procedure A: Align the Red Dot Pointer to the Cutting Beam
If you are performing the alignment due solely to a replaced Mirror or X-Axis Rail,
please move on to procedure B. For all other alignments this procedure must be
completed.
Step 1: Remove rear panel
Locate and remove the eight (8) 5/32" Allen screws which secure the lower rear
panel to the engraver. Remove the panel from the engraver.
Step 2: Attach alignment target
Locate the alignment target and place it into the left side of the lens carriage.
Laser Alignment
Fusion CO2
Revision Date: 10/10/2013 pg. 5 of 18