Epilog Laser Epilog Fusion CO2 Manual page 14

Step 9: Check
Once you are confident that you can between Positions #1, #2 and #3, jog the
lens carriage to Position #4.
If all of the mirrors are aligned correctly, the red dot pointer should appear within
the center ring on the alignment target. If so; you may remove the alignment target,
replace the panels and run a test engraving file. If not; please return to
continue alignment.
Laser Alignment
Fusion CO2
Revision Date: 10/10/2013
4
[Step 3] and
pg. 14 of 18