Advertisement
Mirrors
The three (3) adjustment mirrors used for alignment are on the left side of the
engraver. The mirror numbers correspond directly with the positions on in the bed; for
example, if the lens carriage is in Position #1 than you will only adjust Mirror #1.
Jogging the lens carriage
When moving the lens carriage on the engraver you will be use the "Jog" mode
on the keyboard. When asked to move the lens carriage into a position you only need to
move it as far as practical. Move the carriage as far into the requested corner as you
can while maintaining the ability to see the red dot pointer on the alignment target.
Laser Jog Power
Set the lasers Jog Power to a level that is high enough to mark the tape but not
so high as to burn a large hole in the tape and target. Setting the lasers "Jog" power is
detailed in your machines owner's manual. 10% is a good starting point.
Laser Alignment
Fusion CO2
Revision Date: 10/10/2013
Mirror #2
Mirror #1
Mirror #3
pg. 4 of 18
Advertisement
