Advertisement
Step 3: Align mirror 1
Ensure that the engraver is on and that the Red Dot Pointer is active
Jog the lens carriage to Position 1.
1
Step 4: Align mirror 1
Locate Mirror #1. Using the 3/32" Allan Wrench, adjust the screws on Mirror #1
so that the Red Dot Pointer is in the center of the alignment target.
Location Of Adjustment Screws
Before Adjustment
Laser Alignment
Fusion CO2
Revision Date: 10/10/2013
The key to a good
alignment is repetition and
patience. For the best results
take your time to dial it in.
Adjustment Screw Movement Diagram
After Adjustment
[See
A-7].
pg. 11 of 18
Advertisement
