Teeter FitSpine X Series Assembly Instructions Manual page 13

• Your model's Main Shaft may differ from what is shown in the
figures, however the assembly instructions remain the same.
• Facing the front of the A-Frame, hold the Main Shaft in your left hand
with the height markings facing up. Slide the end of the Main Shaft
into the Main Shaft Housing (Figure 20), located at the base of the
Table Bed.
• With your right hand, pull out the Height-Selector Locking Pin
(Figure 19) to allow the Main Shaft to slide in further and release
in the desired height setting. Refer to the Owner's Manual for more
information on selecting your height setting.
• The Main Shaft MUST REST against the Crossbar bumper on the
A-Frame (Figure 22).
IMPORTANT: The Crossbar prevents the Table Bed from rotating
forward when the user steps on the Ankle Comfort Dial. If the
Main Shaft does not rest on the Crossbar bumper as shown in
Figure 22, then the Table Bed has been assembled backwards
onto the A-Frame.
This MUST BE CORRECTED before use. See also Image B on Page 13
to ensure correct assembly.
• Test the inversion table by hand for smooth and steady rotation
(Figure 23) and ensure that all fasteners are secure.
STEP 5
Assemble Main Shaft to Table Bed
The X1 is shown here. Your actual model may vary.
FIGURE 20
FIGURE 21
FIGURE 22
FIGURE 23
For All Models
11