Teeter FitSpine X Series Assembly Instructions Manual page 12

For All Models For All Models For All Models For All Models
FIGURE 16
FRONT
FIGURE 17
FIGURE 18
FIGURE 19
10
STEP 4
Assemble Table Bed to A-Frame
REAR
FIGURE 18a
TOP VIEW
FIGURE 18b
INSIDE VIEW
The X1 is shown here. Your actual model may vary.
• Face the front of the A-Frame where the Crossbar is located (Figure 16).
• Grasp both Roller Hinges, right above the Cam Lock, and lift the
Table Bed. Allow the top of the Table Bed to rotate toward the floor,
so that the back of the Table Bed is now facing you and the top of the
Table Bed is in front of the Crossbar (Figure 17).
• Lower each Roller Hinge Pivot Pin into the A-Frame hinge plates, one
side at a time (Figure 16). The Self-Locking Hooks will open to allow the
Pivot Pin into the Hinge Plate slot, then automatically snap closed
over the Pivot Pin.
TIP: You may need to push outward on the Hinge Plate in order for
the second Pivot Pin to lock in place.
• Make sure that each Pivot Pin is seated at the base of the slot in the
Hinge Plates, and that the Self-Locking Hooks have closed over both
Pivot Pins (Figures 18a & 18b).
WARNING
!
Failure of the Self-Locking Hooks to close over both Roller Hinge
Pivot Pins is an indication of improper assembly and if not corrected
could result in serious injury or death!
• Rotate the Table Bed into the use position (Figure 19). Ensure that
it rotates smoothly. See also Image A on Page 13 to ensure
correct assembly.