Teeter FitSpine X Series Assembly Instructions Manual page 11

Assemble Roller Hinges to Table Bed
NOTE: Some models come with Traction Handles pre-assembled to
the Roller Hinges. The assembly instructions detailed below still apply.
• Familiarize yourself with the 3-Hole Roller Hinge and Cam Lock
terms (Figure 11).
WARNING
!
NEVER disassemble the Roller Hinge Pivot Pin.
ALWAYS insert the 3-Hole Roller Hinge (with the Pivot Pin on top
and facing out) in the same direction as the arrow label located
inside of the Cam Lock for proper assembly.
• For ease of assembly, rest the Table Bed against the Crossbar
(Figure 12) at the front of the A-Frame.
• On one side of the Table Bed, lift and hold the Cam Lock up all
the way to unlock (Figure 13).
• In your other hand, hold one Roller Hinge near the Pivot Pin.
With the Pivot Pin facing out (away from the Table Bed), slide the
bottom of the Roller Hinge between the Cam Lock and
in the same direction as the arrow label located inside of the Cam Lock.
TIP: Make sure that the Cam Lock is completely open when inserting
the Roller Hinge, otherwise assembly will be more difficult.
• Engage one of the holes in the Roller Hinge over the Bracket Pin.
Figure 13 shows the Roller Hinge installed correctly, with the
Bracket Pin engaged in Setting C.
NOTE: Refer to the Owner's Manual for an explanation of the hole
settings. If you are unsure, use Setting C to start.
• Push down on the Cam Lock (Figure 14) to lock it and secure the
Roller Hinge.
• Repeat on other side. Make sure the Roller Hinges are in the
same hole setting on both sides.
STEP 3
the Bracket
The X1 is shown here. Your actual model may vary.
FIGURE 11
UNLOCKED
Pivot Pin Bracket Pin
FIGURE 12
FIGURE 13
UNLOCK
FIGURE 15
A
For All Models
LOCKED
Bracket Cam Lock
FIGURE 14
LOCK
C
B
9