Teeter FitSpine X Series Assembly Instructions Manual page 14

For All Models
FIGURE 24
FIGURE 25
12
STEP 6
Attach Angle Tether & Head Pillow
The X1 is shown here. Your actual model may vary.
Attach Angle Tether
• The tether will come pre-assembled to the A-Frame.
• Unfold the adjustable tether and clip it to the U-Bar on the
underside of the Table Bed (Figure 24).
• Slide the buckle to lengthen or shorten the strap depending on
your desired maximum angle of inversion.
SHORTEN
EZ-Angle Tether Accessory
Some models may come with the EZ-Angle Tether, embroidered
with color-coded angle markers at 20° (GREEN), 40° (ORANGE),
or 60° (RED). Simply slide the buckle so its center aligns with your
desired color setting.
Attach Head Pillow
Attach the Head Pillow by securing the Velcro Straps through the
specified holes in the Table Bed (Figure 25), which allow the pillow
to shift with the user when in use. You may also customize the
position depending on your preference.
LENGTHEN