Teeter FitSpine X Series Assembly Instructions Manual page 10

For All Models
FIGURE 9
1
1 Support Beam
2 Upper Support Arms
FIGURE 10
8
STEP 2
Assemble Table Bed
• Locate the Table Bed Assembly Hardware Kit (HK1010).
• Place the Table Bed face down on the floor and push down on the
Support Beam, so the two holes align evenly with the holes at the
base of the Upper Support Arms (Figure 9). You may have to exert
extra pressure to ensure that the Support Beam slides over the
2
rubber spacers.
• Insert the two Bolts into the open holes (Figure 10).
• Thread a Washer and Nut onto each Bolt and hand-tighten.
• Using the 6mm Allen Wrench to steady the bolts, tighten the Nuts
onto the Bolts with the 10/13mm Open-Ended Wrench.