Clone Mode - Uniden SC200 Operating Manual

A few notes about the frequency download order:
1.
The scanner fills up less than its allotted 200 channels if
there are not more than 200 of the above types of
licenses in your area.
2.
If there are more than 200 of the above listed types of
licenses, or you have locked-out some banks prior to the
download using the Program Lock feature, the scanner
may run out of memory locations and you may not, for
example, receive part or all of your county, state or
nationwide data.
3.
If you wish to also receive a download of frequencies
from an adjacent county, lock those banks you wish to
keep, shut the scanner off, turn it back on again and
enter the SmartScanner download mode. Then enter a
zip code from a community within the adjacent county.
4.
The SmartScanner editors used their best efforts to
delete digital and MDT (mobile data terminal) computer
records from the database; however, it would be
impossible to delete them all. Therefore, you may hear
some non-voice transmissions on the frequencies
downloaded into your scanner. If not, then you should
lock these frequencies out or delete them by entering a
new frequency or entering 0,
5.
The database will be updated every 6 to 12 months at
a minimum.

Clone Mode

You can clone the frequency data of one SC200 scanner to
another. After connecting the two scanners, using the
Scanner to Scanner steps (See page 39), make sure the
scanners are turned off. On each scanner, press and hold
REM key and turn the radio on.
1.
On each scanner, press
until this screen is displayed on both scanners. Then
press . (Clone Mode)
.
. Or press
45
or