Location; Cleaning; Repairs - Uniden SC200 Operating Manual

6. Insert the battery pack
by placing the bottom
in the case first. Make
sure it is seated within
the case before
replacing the battery
cover.
7. Replace the battery
cover by putting the
two tabs in the
corresponding opening
and sliding it upward
until it locks in place.

Location

n
If strong interference or electrical noise is received,
relocate the scanner or its antenna away from the
source of the noise. A higher elevation, if possible, may
provide better reception.
n
Do not use the scanner in high-moisture environments
such as the kitchen or bathroom.
n
Avoid placing the unit in direct sunlight or near heating
elements or vents.
n
Do not plug the scanner into an outlet controlled by a
wall switch as prolonged periods without power will
cause scanner memory loss.

Cleaning

n
Disconnect the power to the unit before cleaning.
n
Clean the outside of the scanner with a mild detergent.
n
To prevent scratches, do not use abrasive cleaners or
solvents. Be careful not to rub the LCD window.
n
Do not use excessive amounts of water.

Repairs

Do not attempt any repair. The scanner contains no
serviceable parts. Contact the Uniden Customer Service
Center or take it to a qualified repair technician.
48