Deleting A Stored Frequency; Programming With Search - Uniden SC200 Operating Manual

6.
If that frequency is already stored in another channel,
you will hear a "beep", and the other channel number will
appear on the display. If you want to store the frequency
in the selected channel (18) as well, press
The frequency will blink twice to confirm the programming.
Or, you can press
currently selected channel.
Note: Any frequency already stored in any channel will
automatically be replaced by the new one.
7.
If you try to enter a frequency that is outside one of the
12 Bands, you will hear a "beep", and the word "Error "
appears on the display.
Press
8.
To program another channel, repeat the above
procedures.

Deleting a Stored Frequency

To delete a frequency from a channel:
1.
Display the channel and frequency that is to be deleted.
2.
Press
3.
Press
display shows 000.0000.
Note: That channel will be skipped during scanning.
B. Programming with Search
The Search feature enables you to rapidly search for active
frequencies within the specified band limits. When an
interesting frequency is found, you can store it into a
channel using the procedure below. For more information
about SEARCH Mode, see the section titled "Searching".
1.
Press and hold
SEARCH Mode.
and enter another frequency for the
and re-enter the correct frequency.
on the numeric keypad.
. The current channel is erased, and the
/ BAND to enter the BAND
20
again.